Power Outage - GE JGBP86 Owner's Manual & Installation Instructions

Usingthe upperoven.
vvvvw.GEAppliances.com
Toavoid possible bums, place the shelves in the desired posifion before you turn the oven on.
Before you begin...
The shelves have stop-locks, so that when
placed correctly on the shelf supports (A
through E), thex will stop beflwe coming
completely out, and will not flit.
_\_ten placing and remo_ino_ cookware,
pull the shelf out to the bump on the shelf
mI_port.
To remove a shelf, pull it toward you, tilt the
ti'ont end up and pull it out.
Toreplace,
place the end of the shelf (stoI>
locks) on the support, tilt up the ti'ont and
push the shelf in.
NOTE: Theshelf Is not desl)ned to slide out at the
special low shelf (R)position.
The oven has 5 shelf positions.
It also has a special low shelf
position (R) for extra large items,
such as a large turke,¢
Plastic items on flTe cooktop may
melt if left too close to the vent.
Vent appearance and location var_¢
Upper Oven Vent
Your oven is vented through ducts at the
rear of the range. Do not block these ducts
when cooking in the oven--it is important
that the flow (ff hot air fl'om the oven and
ti'esh air to the oven burner be
tminterrupted. Avoid touching the vent
openings or nearby stlrfilces dtwing
oven or
broiler operation--they may become hot.
Handles of potsandpanson thecooktop may
become hot if left toodose to thevent
Do not leaveplastic or flammable items on the
cooktop--they may melt or ignite if left too close
to the vent
Do not leave closed containers on the cooktop.
Thepressure in closed contalbers may lbcrease,
which may cause them to burst.
Metal items wi// becomevery hot if they are left
on the cooktop,and could causebums.
Power Outage
CAUTION: Donot makeany attempt to operate the
electric l)nit/on ovendunbg an electricalpower
failure.
The oven or broiler cmmot be lit dtwing a
power fifilm'e. (;as will not flow tmless the
glow bar is hot.
If the oven is in use when a power failm'e
occms, the oven burner shuts off and
cmmot be reqit tmtil power is restored. This
is because the flow ot gas is automatically
stopped and will not resume when power is
restored tmtil the glow bar has reached
operating temperature.
Upper Oven Light
Touch
the OVENLIGHTpad on the upper
control panel to mrn the light on or ofl_
On some models,
the OVENLIOHT switch is
on the lower fl'ont control
panel.
13