To Assemble Grass Catcher - Craftsman 917.374552 Owner's Manual

Rotary lawn mower 700 series briggs & stratton engine power-propelled, electric start 22" multi-cut
Hide thumbs Also See for 917.374552:
Table of Contents

Advertisement

Available languages

Available languages

TO ASSEMBLE
GRASS CATCHER
1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings over frame.
NOTE:
If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
Frame
Vinyl
bindings
Frame
opening
TO PREPARE
BATTERY
NOTE: Your battery must be charged
before you can start your lawn mower.
1. Open battery box.
2. Connect battery charger connector
(male) to harness connector
(female).
3. Plug battery charger into 110 volt A.C.
outlet.
4. Leave battery charger connected for
24 hours before starting your engine
for the first time.
5. After charging, disconnect
harness
connector (female) from battery char-
ger connector (male).
Connect your battery charger to charge
battery as required.
IMPORTANT:
The engine will not re-
charge your battery.
At the end of the mowing season the
battery should be charged for 48 hours to
,_otect the battery during winter storage.
CAUTION:
Always disconnect
the
harness connector to prevent accidental
starting when transporting
or storing your
lawn mower after the season.
Battery
Harness
connector
(female)
ger
connector
_
(male)
Battery
box
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be
used as a mulcher. To convert mower to
bagging or discharging,
see "TO CON-
VERT MOWER" in the Operation section
of this manual.
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents