To Assemble Grass Catcher - Craftsman 944.362420 Owner's Manual

BRIGGS & STRATTON 4-CYCLE ENGINE
684
584
1
54
50
585
51
306
869
870
7
307
5
45
40
868
45
35
40
34
13
36
33
635
337
29
383
32A
745
28
923
922
27
621
25
27
935
26
1160
MODEL NUMBER 123K07-0225-E1
287
2
3
871
718
8
16 9
24
1019 LABEL KIT
1058 OWNER'S MANUAL
146
741
32
48
4
12
46
15
20 22
24

TO ASSEMBLE GRASS CATCHER

1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
847
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
523
842
Catcher
frame
handle
525
524
11
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to
be used as a mulcher. To convert to
bagging or discharging, see "TO CON-
VERT MOWER" in the Operation section
of this manual.
10
43
TO PREPARE BATTERY
NOTE: Your battery must be charged
before you can start your lawn mower.
1. Disconnect engine battery connector
(male) from battery connector (female)
2. Connect battery charger connector
(male) to battery connector (female).
3. Plug battery charger into 110 volt A.C.
outlet.
4. Leave battery charger connected for
24 hours before starting your engine
for the first time.
5. After charging, connect engine
connector (male) to battery connector
(female).
Your engine has an integral alternator for
Vinyl
partial charging. Connect your battery
bindings
charger to charge battery as required.
IMPORTANT: The engine alternator will
not charge a discharged battery.
At the end of the mowing season the
Frame
battery should be charged for 48 hours to
opening
protect the battery during winter storage.
CAUTION: Always disconnect the
engine connector (male) from the battery
connector (female) to prevent accidental
starting when transporting or storing your
lawn mower after the season.
Charger connector
(male)
Engine connector (male)
5
Battery connector
(female)
Battery charger