Marvell Raid Utility - Asus P8Z68 DELUXE User Manual

4.4.5

Marvell RAID utility

The onboard Marvell SATA 6.0 Gb/s controller allows you to create a RAID 0 or
RAID 1 array using two SATA hard disk drives. Refer to Chapter 2 of your motherboard user
manual for the exact location of the Marvell SATA 6.0 Gb/s connector.
To enter the Marvell utility, press <Ctrl> + <M> during POST.
All exisiting data on the hard disk drives will be erased when creating or deleting a RAID
array. Ensure that you have back up all your data in your hard disk drives before making
any change to the drive status.
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Topology
HBA 0: Marvell 0
├ Virtual Disks
Free Physical Disks
└
├ PD 0: ST3160812AS
└ PD 8: ST3160812AS
Help
Marvell RAID on chip controller.
ENTER: Operation
Create a RAID Array
Move the selection bar to HBA 0: Marvell 0 and press <Enter>.
1.
Select Configuration Wizard and press <Enter>.
2.
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Configure->Select free disks
HBA 0: Marvell 0
Virtual Disks
├
Free Physical Disks
└
* ├ PD 0: ST3160812AS
└ PD 8: ST3160812AS
Help
Use space bar to select the free disks to be used in the array.
ENTER: Operation
3. Press <Space> to select the hard drives to be included in the RAID array.
An asterisk (*) appears in front of the selected hard drive. After selecting all the drives
needed for the RAID array, press <Enter> to continue.
ASUS P8Z68 Deluxe
Information
Vendor ID :
Device ID :
Revision ID :
BIOS Version :
Firmware Version:
PCIe Speed Rate :
Configure SATA as:
▶
F10: Exit/Save ESC: Return
Port ID :
PD ID :
Type :
Status :
Size :
Feature Support :
Current Speed :
Model :
Serial :
FW Version :
▶
SPACE: Select F10: Exit/Save
1B4B
9130
B1
1.0.0.1028
2.2.0.1105
5.0Gbps
AHCI Mode
▶
0
0
SATA PD
Unconfigured
152626MB
MCQ 3G 48Bits
3G
ST3160812AS
9LS0F4HL
3.AAE
▶
ESC: Return
4-19