3.
Marvell
Serial ATA 6.0 Gb/s connectors
®
(7-pin SATA6G_E1/E2 [navy blue])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
•
These connectors are set to [AHCI] by default.
•
You must install Windows
Serial ATA hard disk drives.
Before creating a RAID set, refer to section 4.4.5 RAID configurations or
•
the manual bundled in the motherboard support DVD.
•
When using hot-plug and NCQ, set the Marvell Controller item in the BIOS
to [AHCI Mode]. Refer to section �.5.6 Onboard Devices Configuration
for details.
ASUS P8P67 WS Revolution
XP Service Pack 3 or later versions before using
®
2-19