General Controls - Emerson ES58 Owner's Manual

OPERATING INSTRUCTIONS
• Make sure that the FM Wire Antenna is fully extended.
• Make sure that the AM Loop Antenna is properly installed.
• Make sure that you have installed batteries in the remote control.
• Make sure that the AC power cord is connected to an outlet that
is always "live". Do not connect to an outlet that is controlled by
a wall switch.

GENERAL CONTROLS

Volume Adjustments
Press the VOLUME + or – comtrol on the front panel or the buttons on the remote
control to increase or decrease the volume. The volume level indicator appears in
the main display. The range is from "00" (Minimum) to "30" (Maximum). The system
remembers the volume level when the power is switched ' Off' and returns to the
same level when the power is switched ' On' again.
P.EQ (Preset Equalizer) Button
This system has a 3-Band Preset Electronic Equalizer that allows you to adjust the
tone output for the most popular types of music. The settings are "CLASSIC",
"ROCK", "POP" or flat (EQ ' Off' ).
To change the EQ setting press the EQ button on the front panel or on the remote
control until the desired setting appears in the main display. When no EQ indicator
appears, the EQ is ' Off' .
MUTE Button
To temporarily shut off the sound from the speakers press the MUTE button. The
MUTE indicator will appear in the display and the sound will stop. Press the MUTE
button again to cancel Mute and restore the sound. The MUTE indicator will disappear
from the display.
ES58_012904.p65
12
12 29/1/2004, 15:24