Setting The Raid Item In Bios; Intel ® Matrix Storage Manager Option Rom Utility - Asus P6T SE - Motherboard - ATX User Manual

4.4.3

Setting the RAID item in BIOS

You must enable the RAID function in the BIOS Setup before creating RAID set(s) using
SATA HDDs. To do this:
1. Enter the BIOS Setup during POST.
Go to the Main menu > Storage Configuration, and then press <Enter>.
2.
Set the Configure SATA as item to [RAID].
3.
4. Save your changes, and then exit the BIOS Setup.
Refer to Chapter 3 for details on entering and navigating through the BIOS Setup.
4.4.4 Intel Matrix Storage Manager option ROM utility
®
The Intel Matrix Storage Manager Option ROM utility allows you to create RAID 0, RAID 1,
®
RAID 10 (RAID 0+1), and RAID 5 set(s) from Serial ATA hard disk drives that are connected
to the Serial ATA connectors supported by the Southbridge.
To enter the Intel Matrix Storage Manager option ROM utility:
®
1. Turn on the system.
2. During POST, press <Ctrl+I> to display the utility main menu.
Intel(R) Matrix Storage Manager option ROM v8.0.0.1038 ICH10R wRAID5
Copyright(C) 2003-08 Intel Corporation. All Rights Reserved.
1. Create RAID Volume 3. Reset Disks to Non-RAID
2. Delete RAID Volume 4. Exit
RAID Volumes:
None defined.
Physical Disks:
Port Drive Model Serial # Size Type/Status(Vol ID)
0 ST3160812AS 9LS0HJA4 149.0GB Non-RAID Disk
1 ST3160812AS 9LS0F4HL 149.0GB Non-RAID Disk
2 ST3160812AS 3LS0JYL8 149.0GB Non-RAID Disk
3 ST3160812AS 9LS0BJ5H 149.0GB Non-RAID Disk
[↑↓]-Select
The navigation keys at the bottom of the screen allow you to move through the menus
and select the menu options.
The RAID BIOS setup screens shown in this section are for reference only and may not
exactly match the items on your screen.
The utility supports maximum four hard disk drives for RAID configuration.
ASUS P6T SE
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
[ESC]-Exit [ENTER]-Select Menu
4-11