Asus P65UP5-PKND User Manual page 25

III. INSTALLATION
7. IDE Activity LED (IDE LED)
This connector connects to the hard disk activity indicator light on the system
cabinet. Read and write activity by devices connected to the Primary or Second-
ary IDE connectors will cause the LED to light up.
IDE Activity LED Lead
8. IrDA-compliant Infrared Module Connector (IR)
This connector supports the optional wireless transmitting and receiving infra-
red module. This module mounts to a small opening on system cases that sup-
port this feature. You must also configure the setting through BIOS setup in
Chipset Features to select whether UART2 is directed for use with COM2 or
IrDA. Use the five pins (as defined by Intel) as shown below (Back View) and
connect a ribbon cable from the module to the baseboard according to the pin
definitions. The ribbon cable that may be supplied may either have five or ten
pins (for other standards). If using a ten-pin ribbon cable, use only the top five
row of the ribbon cable plug.
Infrared Module Connector
ASUS P/I-P65UP5 User's Manual
TIP: If the case-mounted LED
does not light, try reversing
the 2-pin plug.
IDE LED
+
For the infrared feature to be available, connect an
infrared module (optional) to the baseboard.
Front View
+5V
NC
IRRX
GND
IRTX
Back View
+5V
IRTX
NC
GND
IRRX
25