A Error Messages And Indicators; Bios Beep Codes; Bios Error Messages; Beep Codes - Intel D945GBO Product Manual

A Error Messages and Indicators

Desktop board D945GBO reports POST errors in two ways:
•
By sounding a beep code
•
By displaying an error message on the monitor

BIOS Beep Codes

The BIOS also issues a beep code (one long tone followed by two short tones) during POST if the
video configuration fails (a faulty video card or no card installed) or if an external ROM module
does not properly checksum to zero. Table 12 lists the BIOS codes.
Table 12.

Beep Codes

Beep Description
3 No memory
Siren CPU overheat (on reboot)

BIOS Error Messages

When a recoverable error occurs during the POST, the BIOS displays an error message describing
the problem. Table 13 gives an explanation of the BIOS error messages.
Table 13.

BIOS Error Messages

Error Message
PROCESSOR_THERMAL_TRIP_ERROR
MULTI_BIT_ECC_ERROR
SINGLE_BIT_ECC_ERROR
CMOS_BATTERY_ERROR
CMOS_CHECKSUM_ERROR
CMOS_TIMER_ERROR
MEMORY_SIZE_DECREASE_ERROR
INTRUDER_DETECTION_ERROR
SPD_TOLER_ERROR
MEM_OPTIMAL_ERROR
Explanation
CPU was previously shutdown due to a thermal event
(overheating).
The firmware has detected that a Multi-Bit ECC Error occurred.
The firmware has detected that a Single-Bit ECC Error occurred.
The firmware has detected that a CMOS battery failure occurred.
The firmware has detected that a CMOS Checksum Error
occurred.
The firmware has detected that the system date/time has not
been set.
The firmware has detected that the system memory has
decreased.
The system chassis was opened.
SERIAL PRESENCE DETECT (SPD) device data missing or
inconclusive. Properly programmed SPD device data is required
for reliable operation. DDR2 533 MHz memory assumed at
slowest timings.
The installed amount of memory in Channel A is not equal to the
amount of memory in Channel B. Maximum memory
performance is achieved with equal amounts of memory installed
in each channel.
63