Driver Installation Guide - ASROCK B75M-DGS Quick Installation Manual

Chassis Intrusion Header
(2-pin CI1)
(see p.2, No. 24)

2.10 Driver Installation Guide

To install the drivers to your system, please insert the support CD to your optical
drive fi rst. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from top to bottom to
install those required drivers. Therefore, the drivers you install can work properly.
2.11 Installing Windows
XP 64-bit Without RAID Functions
If you want to install Windows
OS on your SATA / SATA2 / SATA3 HDDs without RAID functions, please follow the
procedures below according to the OS you install.
2.11.1 Installing Windows
If you want to install Windows
HDDs without RAID functions, please follow the steps below.
AHCI mode is not supported under Windows
Using SATA / SATA2 / SATA3 HDDs without NCQ function
STEP 1: Set Up UEFI.
A. Enter UEFI SETUP UTILITY
B. Set the option "SATA Mode Selection" to [IDE].
®
STEP 2: Install Windows
2.11.2 Installing Windows
Without RAID Functions
If you want to install Windows
/ SATA2 / SATA3 HDDs without RAID functions, please follow the steps below.
ASRock B75M-DGS Motherboard
This motherboard supports
1 CASE OPEN detection feature
GND
that detects if the chassis cover
Signal
has been removed. This feature
requires a chassis with chassis
intrusion detection design.
®
7 / 7 64-bit / Vista
® TM
7 / 7 64-bit / Vista / Vista
®
XP / XP 64-bit Without RAID Functions
®
XP / XP 64-bit OS on your SATA / SATA2 / SATA3
Advanced screen
XP / XP 64-bit OS on your system.
®
7 / 7 64-bit / Vista
® TM
7 / 7 64-bit / Vista / Vista
TM TM
/ Vista 64-bit / XP /
TM
64-bit / XP / XP 64-bit
®
XP / XP 64-bit.
Storage Confi guration.
TM TM
/ Vista 64-bit
TM
64-bit OS on your SATA
25