Gigabyte GA-880GM-UD2H User Manual page 78

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). En-
sure OnChip SATA Controller is enabled under Integrated Peripherals. To enable RAID for the SATA2_0~3
connectors, set OnChip SATA Type to RAID. To enable RAID for the SATA2_4 and eSATA connectors, set
OnChip SATA Type to RAID and set OnChip SATA Port4/5 Type to As SATA Type (Figure 1).
OnChip SATA Controller
OnChip SATA Type
OnChip SATA Port4/5 Type
Onboard LAN Function
Onboard LAN Boot ROM
 SMART LAN
Onboard Audio Function
Onboard 1394 Function
OnChip USB Controller
USB EHCI Controller
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
Onboard Serial Port 1
hi : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Appendix
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[RAID]
[As SATA Type]
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[3F8/IRQ4]
F10: Save
Figure 1
- 78 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults