If Something Goes Wrong - Electrolux EOB 68713 User Manual

42 electrolux

If something goes wrong

If the oven is not working correctly, please carry out the following checks, before
contacting your local customer care department.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by
incorrect use or installation, a charge will be made even if the appliance is under guarantee.
PROBLEM
The oven is not heating up.
The oven light does not come
on.
Steam and condensation
settle on the food and in the
oven cavity.
A fault code (letter F followed
by digits) appears in the clock
display.
SOLUTION
Touch key , then select a cooking function.
o r
Has the fuse in the domestic electrical
installation been tripped?
o r
Check whether the appliance is correctly
connected and the socket switch or the
mains supply to the oven is ON.
o r
The "Demo" function has been accidentally
activated. To deactivate it proceed as follows:
1. In the Off position press key
5 seconds. The oven turns to stand by and
off again. A sound signal will be emitted.
2. Within 5 seconds press at the same time
the keys and
pressed until a sound signal will be emitted.
If the "Demo" word disappears at the next
switch then operation is successfull.
Select a cooking function.
o r
Buy a new oven light bulb; if necessary, order
from the Electrolux Service Centre and install
according to the instructions in this user manual.
When the cooking process is completed,
do not leave the dishes standing in the
oven for longer than 15-20 minutes.
Switch the appliance off and on again via the
house fuse or the safety switch in the fuse box.
If it is displayed again, please take note of the
fault code and contact the nearest customer
care department.
for about
keys and hold them