Power Source; Protect Your Furniture - Emerson NR303TT Owner's Manual

POWER SOURCE

This product is designed to operate on normal 120V 60Hz AC only. Attempting to
operate this system from any other power source may cause damage to the system,
and such damage is not covered by your warranty.
NOTE: You will note that this system is equipped with a polarized AC power plug
having one blade wider than the other. This is a safety feature. If this plug does not
fit into your existing AC outlet, do not
try to defeat this safety feature by filing
the wide blade to make it fit into your
outlet. If this plug will not fit into your
AC Outlet
outlet, you probably have an out-
dated non-polarized AC outlet. You
AC Plug
should have your outlet changed by
a qualified licensed electrician.

PROTECT YOUR FURNITURE

This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber 'feet' before you place the product on fine wooden furniture.
IMPORTANT: Raising And Lowering The Lid
To open the lid, raise it as far as it will go until the lid support bracket ' locks' in the
open position.
To close the lid, lift it upward slightly until the lid support bracket ' unlocks' , and then
gently lower the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID
CLOSED. ALWAYS RAISE THE LID TO RELEASE THE LID SUPPORT BRACKET.
6
NR303TT_050704.p65 6 7/5/2004, 10:14