Electrolux ENB 35400 W User Manual page 29

Disassemble the
elements (d2,d3) by unscrewing the
screw (d4) .
Remove stoppers in both doors
(d5,d6).
Reverse the door locking elements
(d2,d3) , move to the other side of the
other door and fix by screwing in the
screw (d4) .
Re-insert the stoppers (d5,d6) on the
other side of the doors.
Remove the left-hand cover pin of the
middle hinge (m3,m4) and move to the
other side.
Fit the pin of the middle hinge (m5)
into the left-hand hole of the lower
door.
Re-insert the lower door on the pivot
pin (b2).
Re-screw the middle hinge (m1) on
the opposite side . Do not forget the
plastic spacer (m2) inserted under the
middle hinge.
Re-insert the upper door on the
middle hinge (m5).
Make sure that the edges of the doors
run parallel to the side edge of the
appliance.
door locking Position and fix the upper hinge (you
can find them in the instruction for use
bag) on the opposite side (t6).
Insert the panel (t7) (that can be found
in the instruction for use bag).
Open the upper door, attach the top
cover (t2) using screws (t1). Insert the
magnet (d7). Close the door.
Reposition, level the appliance, wait
for at least four hours and then
connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the ca
inet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the
natural fitting of the gasket or accelerate
this process by heating up the part
involved with a normal hair drier.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The
After Sales Service specialist will carry
out the reversibility of the doors at your
cost.
electrolux 29
GB
t6
t7