Table of Contents
Advertisement
Appendices
The screws on the
lamp cover and the
lamp cannot be
removed.
The projector
cannot be turned
on if the lamp
cover has not been
placed back on the
projector.
Do not touch the
glass area of the
lamp. Hand oil can
cause the lamp to
shatter. Use a dry
cloth to clean the
lamp module if it
was accidentally
touched.
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the " " button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Unscrew the two screws on the cover. 1
5. Lift up and remove the cover. 2
6. Unscrew the two screws on the lamp module. 3
7. Lift up the lamp handle and remove the lamp module slowly and carefully. 4
To replace the lamp module, reverse the previous steps.
8.
Turn on the projector and use "Lamp Reset" after the lamp module is
replaced.
Lamp Reset: (i) Press "Menu" (ii) Select "OPTIONS" (iii) Select
56
English
3
"Lamp Settings" (iv) Select "Lamp Reset" (v) Select "Yes".
1
2
4
Advertisement
Table of Contents
