Lenovo Aptiva Hardware Maintenance Manual page 82

Error Symptoms
Diskette drive test failed.
NOTE:
Ensure hard disk drive is configured correctly in
Configuration/Setup Utility, cable/jumper are set
correctly before diagnosing any hard disk drive
problems.
Hard disk drive test failed.
Hard disk drive format error. 1. Enter Configuration/
Hard disk drive write error.
Hard disk drive LED fails to
light, but system operates
normally.
48 IBM Desktop System HMM
1. Diskette
2. Diskette drive
3. Diskette drive cable
4. System board
Hard Disk Drive
1. Enter Configuration/
Setup Utility and Load
default settings.
2. Hard disk drive cable.
3. Hard disk drive.
4. System board.
Setup Utility and Load
default settings.
2. Hard disk drive cable.
3. Hard disk drive.
4. System board.
1. Enter Configuration/
Setup Utility and Load
default settings.
2. Hard disk drive.
1. With the system power
on, measure the voltage
of hard disk LED
connector CN6. The
reading should be:
CN6 HDD
pin-1 pin-1 +5Vdc/ -
pin-2 pin-2 +5Vdc/0Vdc
pin-3 pin-3 +5Vdc/0Vdc
pin-4 pin-4
2. See "System Board
Jumpers and
Connectors" on page
109.
3. Hard drive LED cable.
Action/FRU
Idle /Active
+5Vdc/ -