Air Flow Direction Adjustment Procedure; Emergency Run Operation - Mitsubishi Daiya SKM22ZD-S User Manual

Air flow direction adjustment procedure

Up/down direction can be adjusted with the AIRFLOW button on the remote control. Each time when you press this button the mode changes
as follows:
Change to AIRFLOW mode.
Air scroll
In COOL and DRY operation
Stops at this position
for 5 seconds.
Thick line : moves quickly
Thin line : moves slowly
NOTE
• If the room temperature control (thermostat) switches to the heating mode or if the defrosting operation is on, the blow flap changes automatically to a horizontal
position.
• If the heating operation has just started and the room temperature is still low, it may take a while before the flap moves to the above sway operation angle.
• The flap may stop at the tilted down-blow position during the "sway operation" in the heating mode.
MEMORY FLAP (FLAP STOPPED)
When you press the AIRFLOW button once while the flap is operating, it stops swinging at an
angle.Since this angle is memorized in the micro-computer, the flap will automatically be set at this
angle when the next operation is started.
• Recommended angle of the flap when stopping
HEAT
• Avoid constant airflow to the body for hours on end.
• When in COOL or DRY operation, do not operate for hours on end with the air
flow blowing straight down. Otherwise, condensation may appear on the outlet
grill and drip down.
• Do not try to adjust the flaps by hand, as the control angle may change or the flap
may not close properly.

Emergency run operation

• The ON/OFF button on the unit operates ON/OFF temporarily when the remote control is not used.
Operation program
• OPERATION MODE :
• FAN SPEED
• AIR FLOW
• Operation starts by pressing the ON/OFF button; it stops if you press the button again.
Adjusting up/down air flow direction
(Air scroll)
In HEAT operation
Stops at this position
for 5 seconds.
Thick line : moves quickly
Thin line : moves slowly
(Slant forward COOL, DRY
blowing)
DANGER
CAUTION
AUTO
: AUTO
: AUTO
(SWING) (flap stopped)
SWING FLAP
Adjusting left/right air flow direction
Adjust the direction by moving the left/right
air flow fin by hand.
(Horizontal
blowing)
– 10 –
Flap moves up and down
continuously.
CAUTION
Please stop the air conditioner when
adjusting the air flow direction.
Unit ON/OFF button