Hunter 21313 Owner's Manual And Installation Manual page 15

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-9. To uninstall the light fixture, first disconnect the plug connectors
between the black wire and the black wire with a white
stripe.
7-10. Disconnect the plug connectors between the two white
wires.
7-11. Remove the two screws attaching the light kit to the lower
switch housing.
7-12. Remove the light fixture from the lower switch housing,
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other plug
connector (female) through the hole.
7-13. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
7-14. Install the switch housing cap and plug button to the lower
switch housing.
7-15. Once you have uninstalled the light fixture, continue
with Step 7-1.
Male Dummy
Female Dummy
Terminal
Terminal
15
42666-01 • 06/16/10 • Hunter Fan Company
Lower
Switch Housing
Threaded Rod
Steps 7-11 – 7-13
Cap
Plug Button
Step 7-14