Table of Contents
Advertisement
Programme Selection (Direct Access)
•
Press numeric buttons on the remote control to select
programmes between 0 and 9. The TV will switch
to the selected programme. To select programmes
between, press the numeric buttons consecutively.
When the pressing time is due for the second
numeric button, only the fi rst digit programme will
be displayed. Press directly the programme number
to reselect single digit programmes.
Note: If the background is transparent, on screen texts
will be slightly transparent as well.
First Time Installation
IMPORTANT: Ensure that the
connected and a Common Interface module is not
inserted before switching on the TV for the fi rst
time installation.
•
When the TV is operated for the fi rst time, installation
wizard will guide you through the process. First,
language selection screen will be displayed:
•
Use "
" or " " buttons to select your language
and press OK button to set selected language and
continue.
•
After selecting the language, "
be displayed, requiring you to set Country, Teletext
Language, Scan Encrypted and
(optional) options.
" or " " button, select the country
•
By pressing "
you want to set and press " " button to highlight
Teletext Language option. Use " " or " " button
to select desired Teletext Language.
aerial or cable
is
Welcome!" screen will
Active Antenna
English - 15 -
•
Press "
" button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want to
scan coded stations.
•
After selecting the Scan Encrypted, select
antenna feature (optional) by pressing
button. Use " " or " " button to set active antenna
mode as on or off. If an active antenna is connected
to your TV, you can select this option as On (5V).
Antenna power should be Off when standard
antenna is used instead of the active antenna.
OK button on the remote control to continue
•
Press
and the following message will be displayed on the
screen:
To select the "Yes" or "No" option, highlight the item by
using " " or " " buttons and press OK button.
Afterwards, the following OSD will be displayed on
the screen:
If you select CABLE option, the following screen will
be displayed:
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
numeric buttons on the remote control. Set Start and
Stop Frequency as desired by using numeric buttons
on the remote control. After this operation, you can set
Search Step as 8000 KHz or 1000 KHz. If you select
1000 KHz, the Tv will perform search process in a
detailed way. Searching duration will thus increase
accordingly. When fi nished, press OK button to start
automatic search.
Active
" " or " "
Advertisement
Table of Contents
