Contec CheckMate RT-U49E Programming & Operating Instructions Manual

CheckMate
Model RT-U49E
Universal Remote
Control
Programming & Operating
Instructions
To have a clearer idea of the features and
capabilities of your remote control, take a moment
to carefully read these instructions
Save for future reference.
™
IV
1. Introduction
Your Checkmate IV, Model RT-U49E, universal remote control
is simple to program, easy to use, and can operate up to four
(4) electronic devices, which include:
CABLE
TV
VIDEO
AUDIO
Your remote control is pre-programmed to operate the
Scientific-Atlantra Explorer
converters.
operate your TV, VCR and AUDIO devices.
Programming your remote is a simple procedure using Point
and Press™ Programming, an automatic method whereby the
remote self-programs to each of your devices, eliminating the
need to use codes. Programming your remote can also be
done by entering code numbers.
2. Before Getting Started
Some of the special features on your remote control are:
Cable Pre-Programmed
Your remote control is pre-programmed to operate the
Scientific-Atlantra Explorer
converters. If you are operating either of these converters,
no cable programming is necessary.
Point and Press™ Programming
Lets you program your TV, VCR and Audio devices
without using codes. For more information, see sections
5, 6 and 7.
SmartKeys™
Program multiple button presses on the [CABLE], [TV],
and [BYPASS] buttons. For more information, see section
13.
[DEVICE]
This button lets you select the operating mode of the
remote control.
Press [DEVICE] and the current mode button will
Rev. 02/2001. © 2001, CONTEC CORPORATION
Cable television converters
Televisions
VCR, DVD players
Audio-video (A/V) receivers
Laser Disk (LD) players
DMX & DCR Digital Music Converters
®
and Pioneer Voyager
However, it must be programmed (set-up) to
®
and Pioneer Voyager
illuminate. While the current mode button is illuminated,
press one of the other non-illuminated mode buttons to
operate a different device.
Memory Guard™
Eliminates reprogramming after battery changes provided
new batteries are installed within 4 hours of removal of old
batteries.
3. Installing / Replacing Batteries
Install two (2) "AAA" batteries as indicated by the diagram in
the battery compartment.
®
digital
When the batteries become too weak to operate the remote
control properly, the mode keys will become dim or not
illuminate at all during use. When this happens, install 2 new
"AAA'" size batteries.
Your remote control has Memory Guard , which eliminates
reprogramming after battery changes provided new batteries
are installed within 4 hours of removal of old batteries.
4. Programming Your Cable Converter
Your remote control is pre-programmed to operate the
Scientific-Atlantra Explorer
converters. If you are operating either of these
converters, no cable programming is necessary - proceed
to section 5.
®
digital
If you need to operate another converter, look up the brand
and model number in the Cable Setup Code list. If you are not
sure of your brand and model, contact your cable company.
To program (setup) your cable converter...
1. Turn on your cable converter.
2. Press [DEVICE], then [MUTE] together - hold both buttons
down until the lighted mode buttons start blinking in
sequence.
3. Press [CABLE]. The [CABLE] button will illuminate.
4. From the Cable Setup Code list, locate and enter the 3-
digit code for your brand and model.
5. Press [CABLE] to lock in the code. The [CABLE] button
will blink 2 times and go out.
® ®
and Pioneer Voyager digital