Table of Contents
Advertisement
Quick Reference
The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing the battery.
Two Way Remotes:
First, release the battery cover lock located on the back of the remote. Once the lock is released, gently slide the battery cover off to expose the battery. With the
exception of the 2WSSR-PRO (Uses 1 AA battery) all Firstech 2 Way remotes require one AAA battery.
IMPORTANT: Be sure to observe correct polarity when installing the battery.
One Way Remotes:
First, remove the small Phillips screw located on the back of the remote. Once the screw has been removed, gently pull the remote apart taking care to not damage
the circuit board. 1 Way remote batteries differ among the models. Your battery size should be listed on the battery. Replacements can be purchased from your
local Firstech dealer or an electronics store.
STEP 1: Enter remote programming mode by holding down buttons (II + III) for 2.5 seconds. The remote will beep once and the LCD will read "Prog" to indicate
that you have successfully entered programming mode.
STEP 2 (Pro Remotes): After entering programming mode the time icon will flash indicating to set the time. Adjust the time settings by tapping
button (I) to change the hour and tapping button (II) to adjust the minutes.
STEP 2 (Non Pro Remotes): After entering programming mode tap button (I) and the time icon will flash to set the time. Adjust the time settings
by tapping button (I) to change the hour and tapping button (II) to adjust the minutes.
STEP 3: Once the desired time has been set, exit remote programming by holding down buttons (II + III) for 2.5 seconds. The remote will beep three times
indicating that you have successfully exited programming mode.
By Firstech, LLC
6
Quick Reference
Button
Duration
Additional Programming Function / Description
Required
0.5 seconds
no
Locks doors and/or arms alarm. Tap again to unlock door and / or alarm.
I
Run time extender. Resets remote start and turbo run time while vehicle is remote started
2.5 seconds
yes
0.5 seconds
no
Aux 1. Triggers the auxiliary 1 output (most commonly used for rear defrost or window roll-down)
II
Activates the remote start. Repeat and remote start will shut off
2.5 seconds
no
0.5 seconds
no
Aux 2. Triggers the auxiliary 2 output (most commonly used for rear defrost or window roll-down)
Trunk pop. Triggers the trunk release output and opens the vehicleís trunk
2.5 seconds
no
III
Pro Remotes Only : Turns on the CompuGLO backlight
double tap
no
Car Check (updates vehicle status on remote pager) / Secure Auxiliary / Temperature Display / Vehicle Voltage Display
0.5 seconds
no
Panic/vehicle locater (flashes vehicleís parking lights and sounds siren and horn)
2.5 seconds
no
IV
Pro Remotes Only : Locks buttons and displays "Hold" on screen.
Pro Remotes Only : Panic / vehicle locater (flashes vehicle's parking lights and sounds siren and horm)
4 seconds
no
Turns siren chirps on/off (Note: With the siren chirps off, it will still sound in the event the alarm is triggered)
0.5 seconds
no
I + II
2.5 seconds
no
Option programming menu 1. For use during installation
0.5 seconds
no
Valet mode (see page 8 for details)
I + III
2.5 seconds
no
Turns the shock sensor on/off (Alarm or Alarm / Starter system only)
7
By Firstech, LLC
Hide quick links:
Advertisement
Table of Contents
