Kenmore 4885 - Rear Control High Efficiency 3.6 cu. Ft. Capacity Front Load Washer Use & Care Manual And Installation Instructions page 25

MAINTENANCE (cont.)
Cleaning
the Drain
Pump
Filter
Your washer is equipped with a filter that helps prevent
excess lint and foreign objects like buttons, keys, and
coins from causing damage to the pump. If the washer
fails to drain properly, unplug the washer and allow the
water to cool, if necessary, before proceeding.
NOTE: If there is a large amount of water in the tub, you
may have to empty your container several times.
f /-
Plug
1. Open the drain pump filter access panel.
J
Drain Hose
..2
2. Unclip the drain hose and pull it out. Place the end of
the drain hose into a shallow pan or a floor drain. Use
care not to pull the hose out too far or it may not drain
properly.
3. Remove the plug from the drain hose, and allow the
water to drain completely.
Pump Filter
4. Twist the pump filter counterclockwise to remove.
Remove any lint and foreign objects from the pump
filter.
Reverse the above steps to reinstall the drain pump
filter and drain hose. Be sure to close the cover panel
when finished.
J
25