(2)
C141-E270
Downloaded from
www.Manualslib.com
Notes:
1.
The user can arbitrarily specify the following parameters according to the system
requirements:
•
ARRE
•
AWRE
•
TB
•
PER
2.
The user also can arbitrarily specify parameters other than the above. However, it is
recommended to use the default setting in normal operations.
Disconnection/reconnection parameters (page code = 2)
The following parameters are used to optimize the start timing of reconnection processing to
transfer data on the SCSI bus at a read (READ or READ EXTENDED command) or write
operation (WRITE, WRITE EXTENDED, or WRITE AND VERIFY command) of the disk.
Refer to Chapter 2 "Data Buffer Management" of the SCSI Logical Interface Specifications for
further details.
• Buffer full ratio
• Buffer empty ratio
Notes:
1.
In a system without the disconnection function, these parameters need not be specified.
2.
Determine the parameter values in consideration of the following performance factors of
the system:
•
Time required for reconnection processing
•
Average data transfer rate of the SCSI bus
•
Average amount of processing data specified with a command
Refer to Chapter 2 "Data Buffer Management" of the SCSI Logical Interface
Specifications for how to obtain the rough calculation values for the parameter values to
be set. It is recommended to evaluate the validity of the specified values by measuring
performance in an operation status under the average system load requirements.
manuals search engine
Parameter
Default value
00 (HEX)
00 (HEX)
91