General Information; Diagnosis; Id Number And Id Data Setting - Pioneer DV-38A Service Manual

DV-38A, DV-S88A, DV-S838A, DV-939A

7. GENERAL INFORMATION

7.1 DIAGNOSIS

7.1.1 ID NUMBER AND ID DATA SETTING

Entering the ID Number and ID Data for Players with DVD-Audio Compatibility
It is necessary with a player with DVD-audio compatibility to set an individual number (ID number) and ID data. If the number and data are
not set correctly with the following procedure, operations in the future may not be guaranteed. You will find the ID number to be set on the
yellow label on the rear panel.
Important: If no yellow label is found on the rear panel, write down the specified ID number by checking it according to "How to
confirm the ID number" shown below.
The Input is Necessary When:
• Downloading FLASH-ROM is finished. (The latest version must be downloaded when a repair is made.)
• "No ID Number" is displayed on the screen or FL display immediately after the power is turned on or in Stop mode.
• If "No ID DATA" is displayed, the ID data must be entered.
Note:
Be sure to enter the ID number in Stop mode.
Use the service remote control (GGF1067) for operations. Only opening/closing of the tray are performed from the player.
How to Input the ID Number and ID Data
1 To enter the input mode, press ESC + STEREO in a status with
no ID number set, such as after FLASH-ROM downloading.
2 As number input is enabled when the unit enters the input
mode, input the 9-digit ID number.
(The entered number is also displayed on the FL display.)
[Player's ID Number Setting]
ID Number ?
> - - - - - - - - -
2
<CLEAR> Exit
Input ID Number !
3 After inputting the number, press SEARCH to register the ID
number.
[Player's ID Number Setting]
ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?
<PLAY> Compare Mode
<SEARCH> Enter
3
Input ID Number !
68
4 When the ID number has been registered, the unit enters the ID
data input mode. (The FL display indicates "NO ID DATA.")
In this condition, place the ID data disc on the tray and close the
tray using the CLOSE key "7/0" on the player.
[Player's ID Data Setting]
<CLEAR> Exit
Insert The ID Data Disc !
4
5 While the data are being read, the message shown in the figure
at left is displayed on the screen.
(The FL display indicates "RD ID DATA.")
[Player's ID Data Setting]
Loading The ID Data Disc !
5