When The Error Log Is Displayed - Panasonic WJ-ND300A/10000V Operating Instructions Manual

When the Error Log is Displayed

Do the following when the error log is displayed on the LCD.
Error Log Indication on the
LCD
W-ERR u-d
R-ERR u-d
SKIP u-d
HDu-d 1DOWN HDD-10 ERR
RAID5 1DOWN
HDu 2DOWN
Please Setup on
DISK CONFIG
MENU
SMART u-d HDD-1-u-d ERR
HDD WARNING
H.METER u-d HDD-2-u-d ERR
HDD HOUR METER
V-ERROR vvv
REMOVE u-d HDD-3-u-d ERR
HDD REMOVED
EVT-**% or HDD-5ERR
EVT-FULL
EVENT-HDD FULL
CPY-**% or HDD-6ERR
CPY-FULL
COPY-HDD FULL
CAM cc ERR NET-3-0ERR
CAMERA cc ERROR
LINK_ERR_0p NET-1-p ERR
NW LINK ERROR
CAM cc SD ERR NET_5-0 ERR CAM-
ERA cc SD ERROR
(or no indication)
58
Description
Failed to write/read data on
the HDD.
The HDD may be malfunc-
tioning.
A HDD of RAID is failed.
The unit is currently inoper-
able since the disk array is
changed.
The HDD may be malfunc-
tioning and may work incor-
rectly.
The set time for the hour
meter has passed.
It may be reaching the end
of the HDD's lifetime.
Data on each recording
area is lost by the
"REMOVE" error, etc.
The HDD has been
unmounted from the system
automatically.
The HDD is almost full or
completely full.
Communication with the
network camera is unstable,
or no network camera is
connected.
The unit is disconnected
from the network.
An SD card memory error
occurred. The SD memory
card may be not detected,
or there is no available
space on the SD memory
card on the camera.
Solution
If this error occurs frequently, contact the
dealer to replace the HDD. (*1)
Contact the dealer.
After recovering/replacing the faulty disk, the
error status will be canceled.
Display "DISK CONFIG MENU" and initial-
ize or replace the hard disk.
Contact the dealer to replace the HDD. (*1)
If this error occurs frequently, contact the
dealer to replace the HDD. (*1)
Contact the dealer.
After replacing the faulty disk, the error sta-
tus will be canceled. (*1)
Contact the dealer.
After replacing the faulty disk, the error sta-
tus will be canceled. (*1)
Initialize or replace the HDD. (*1)
Check the communication status between
this unit and the network camera.
Check the network connection.
Check the SD memory card and the settings
on the camera.