Panasonic SC-HTB170 User Manual page 24

Bluetooth
mode
You can select different modes to suit the type of
connections with emphasis on connectivity or high quality
audio.
≥ Make sure that a Bluetooth
with this system. ( 19)
Press [ ] to select " ".
" "
indicator will blink slowly. If the indicator lights, a
≥
Bluetooth device is already connected with this system.
®
Disconnect it. ( 19)
Press [ ] to display the current
mode.
"STANDARD" indicator blinks:
MODE1 (Factory preset)
Emphasis on connectivity
"STEREO" indicator blinks:
MODE2
Emphasis on audio quality
While the mode is displayed, press
[ ] to select the mode.
≥ The setting changes each time [
≥ The indicator for the selected setting blinks for 10 sec and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
24
RQT9841
communication
®
device is already paired
®
] is pressed.
Using the Dolby Virtual
Speaker effect
Depending on your preference, It is possible to turn off the
3D surround effect and the clear-mode dialog effect.
While pressing and holding [SOUND]
on the remote control, press and
hold [VOL i] on the main unit for
more than 4 sec.
"STANDARD" indicator blinks:
3D surround effect and clear-mode
dialog effect is on.
"STEREO" indicator blinks:
3D surround effect and clear-mode
dialog effect is off.
While the setting is displayed, press
[SOUND] to change the setting.
≥ The setting changes each time [SOUND] is pressed.
≥ The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥ This setting will be reset to on when the main unit is turned off.
≥ When off is selected, the dialog effect level cannot be
adjusted.
Dimmer mode
You can turn off dimmer mode and keep the LED
indicators bright.
While pressing and holding [INPUT
SELECTOR] on the remote control, press
and hold [s VOL] on the main unit for
more than 4 sec to turn off Dimmer mode.
≥ The indicator for the current condition will turn brighter.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is on.
To turn on dimmer mode, repeat the operation above.
After performing the operation, the indicator for the current
condition will be dim.