Before Switching On Your Tv; Power Connection; Connections To The Aerial Input Socket; How To Connect Other Devices - Hitachi CL21F65 Instructions For Use Manual

Before Switching on your TV

Power connection

IMPORTANT: The TV set is designed to operate on 220-240V
AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambient room
temperature before you connect the set to the mains.

Connections to the Aerial input socket

• Connect the aerial or cable TV plug into the Aerial input socket
on the back of the TV. If you are also connecting a video re-
corder /satellite receiver, plug the aerial into this equipment
first and then connect the Aerial output socket from this de-
vice to the Aerial input on the back of the TV.
75
VHF/UHF
TV REAR PANEL

How to connect other devices

IMPORTANT: Switch off the TV before connecting any external
device.
Sockets for external connections are at the back of the TV. For
connection of other devices via Euroconnector refer to the
manuals of the related devices.
Inserting batteries in the remote control
handset
• Place the batteries in the right directions as seen below.
• Remove the battery cover located on the back of the handset
by gently pulling upwards from the indicated part.
• Insert two AAA (R03) or equivalent type batteries inside.
• Replace the battery cover.
NOTE: Remove batteries from remote control handset when
it is not to be used for a long period.Otherwise it can be dam-
aged due to any leakage of batteries.

To switch the TV on

Your TV will switch on in two steps:
1- Press the power button located on the front of the TV. Then
2- To switch on the TV from stand-by mode either:
Press a digit button on the remote control so that a programme
number is selected,
or,
Press Programme Up or Down buttons on the front of the TV
or on the remote control, so that last switched off programme
is selected.
In either case the TV will switch on and the RED LED will turn
to GREEN.

To switch the TV off

• Press the stand-by button on the remote control, so the TV will
or,
Press the power button located on the front of the TV, so the TV
will switch off and the GREEN LED will turn off.
You can operate your TV both using the remote control
handset and onset buttons.
CABLE TV
A.P.S. (Automatic Programming System)
"PLEASE, CHECK ANTENNA CABLE. AUTO PROGRAMMING
SYSTEM" message will be displayed when you turn on your TV
for the first time. A.P.S., searches and sorts all channels and
stores them automatically on your TV, according to the trans-
mission of programme systems in your area.
To cancel A.P.S. before starting, press "
choose the "COUNTRY".
The "STANDARD" setting is fixed to "I". You cannot change this
item's setting.
This, will effect the sort process in A.P.S.. To select "START" use
" " or " " button and press " " or " " button. To cancel A.P.S.
during running press " " or " " button.
After A.P.S. is finalized, a programme list will appear on the
screen. In the programme list you will see the programme
numbers and names assigned to the programmes.
If you do not accept the locations and / or the programme
names of programmes, you can change them in Programme
menu.
ENGLISH - 7 -

Switching the TV ON/OFF

the TV switches itself to standby mode and the RED LED
located below the TV illuminates.
switch to stand-by mode and the GREEN LED will become
RED,

Operating the TV

PLEASE CHECK ANTENNA CABLE
AUTO. PROGRAMMING SYSTEM
COUNTRY
STANDARD
START
A.P.S. IS RUNNING
P 07 VHF1
CANCEL
" button. First of all
TV
UK
I
.S.