Table of Contents
Advertisement
Initial Settings
When the TV set is operated for the first time,
the IDTV turns on first.
Because this is the first time the TV is used, there
are no channels stored in the memory and the
following message appears on the screen:
Please ensure aerial is plugged in. Do you
want to start first time installation?
Yes
• To start installation process, select "Yes",
to cancel select "No".
• To select the "Yes" or "No" option, highlight
the item by using
the OK button.
The IDTV will automatically tune to the UHF
transmision channels 21 to 68, searching for
digital terrestrial TV broadcasts and displaying
the names of channels found. This process
will take about five minutes. To cancel
searching, you can press the M button at any
time during the process.
AUTOMATIC SEARCH
Channels:
BBC ONE
BBC TWO
BBC CHOICE
Searching UHF channels 30. Please wait. This will take a few minutes
12 %
Cancel search
MEN U
After Automatic Search is completed, the
following message asking for analogue channel
search appears on the screen:
Do you want to search for
analogue channels?
Yes
To seach for analogue channels, select "Yes".
TV switches to the analogue TV mode. The
menu below is displayed to search for
analogue channels:
No
or
buttons and press
No
Set Language item by pressing
Press
or
and then use
button to highlight Txt. Region. Select a region
by using
or
OK button to continue. To cancel, press the
button.
TV
For more information on this process, see
"Install Menu" section.
NOTE: For proper functioning of digital teletext
in DTV mode, you should set country
as UK in analogue APS.
General Operation
Pressing the TV or DTV button at any time
while watching television programmes will
switch the TV set between displaying the
digital terrestrial television broadcasting and
its normal analogue broadcasting.
Information Banner on DTV
• Whenever you change channel, using the P-
/ P+ button or the numeric buttons, the TV
displays the broadcast picture along with an
information banner at the bottom of the
screen. This will remain on the screen for
approximately three seconds.
• The information banner can also be
displayed at any time while watching TV by
pressing the
control:
- 20 -
Auto. Programming System
Language
Country
Txt. Region
Check the antenna cable
Start : Ok
button to highlight Country item
or
to set. Press
button. When finished, press
button on the remote
English
U.K.
West Europe
Exit : TV
or
button.
or
Advertisement
Chapters
Table of Contents
