Preparations Before Use; Installation - Hitachi R-M700ERU8 User Manual

Preparations before Use

Installation

1. Check the width of the doors of the house.
The refrigerator doors may have to be removed, if the width or depth of the refrigerator are more than width of the house doors.
To remove the refrigerator door, please consult with the retailer.
2. Install the refrigerator in the following place.
and place the refrigerator on the board.
changed due to a heat from the refrigerator.
you may need to apply anti-rust treatment to the piping. Contact your dealer in advance.
A failure caused by that gas damage will not be covered under guarantee.
3. Allow enough space to release heat.
The refrigerator requires enough air ventilation space
around the cabinet to have efficient cooling performance.
And, to open the doors properly, the following
installation space shall be secured.
4. Earthing wiring.
Always ground this refrigerator when using it in places with high humidity
or moisture. (Please consult with retailers.)
Do not connect the ground line to a gas pipe,
Warning
telephone line, or lightning rod.
5. Adjusting the adjustable legs to keep the left/right
refrigerator door level.
Without adjusting the legs, door height may not be level, or there
may be abnormal vibration or noises depending on floor conditions.
Follow the instructions below.
Turn the adjustable legs to lower the adjustable
legs until they touch the floor firmly.
Compare the height of left and right doors and
lower adjustable leg whose door
height is lower than the other until the both door
height become level.
and the door height becomes stable.
leg and turn.
5 cm.
45 cm.
35 cm.
Lower the left adjustable leg
5 cm.
5 cm.
Earthing Terminal
Earthing cord
Adjuster Cover
Adjustable
Leg
Lower the right adjustable leg
5