Charging Status Leds - Motorola CLP1060 User Manual

Note: If the radio is ON while charging, it takes longer to
fully charge.
5. Insert the radio facing down (with battery
installed) into the charging pocket, making sure
the radio contacts are aligned with the MUC
contacts.
Note: The battery can be charged by itself using the slot
on the flat surface of the charging pocket.

Charging Status LEDs

On the drop-in charger, the radio charging pocket
has an LED Charger.
On the MUC, each of the 6 charging pockets has
an LED. The LEDs are grouped into pairs to show
which charging pockets are paired. The LED is red
when the battery is charging. It turns to green
once the battery is fully charged.
Note: This Multi Unit Charger allows you to clone up to 2
radios (2 Source radios and 2 Target radios). For
more details, refer to "Radio Cloning" Section on
page 25.
• For part number details, refer to the"Accessories"
Section on page 44.
Charger LED Indicator
Status LED Status
Charging Steady
Red
Indication
Charge Steady
Complete Green
Indication
Battery Blinking
Fault (*) Red
Note: The LED is red when the battery is charging. It turns
to green once the battery is fully charged.
Note: (*) Re-seating the battery pack likely corrects this
issue.
Comments
The charger is
currently charging.
Battery is fully
charged.
Battery was faulty
when inserted.
17