Lcd Display; Battery Installation - Midland X-TRA TALK LXT500 series Owner's Manual

LCD DISPLAY

1
2
3
CONTROLS
7
8
9
10

BATTERY INSTALLATION

Your LXT500/535 Series radio operates with either a NiMH battery pack
or optional 4 "AAA" alkaline batteries. The belt clip should be removed
to ease installation or removal of the batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see diagram
on next page) for easy access, then remove the Battery Cover by press-
ing down on the top center and sliding it down from the radio.
2. Insert 4 "AAA" batteries observing the polarity as shown. Installing
the batteries incorrectly will prevent the unit from operating or may
damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the
belt clip, making sure it locks into place.
1. LOW BATTERY ICON – Indicates the
2. TRANSMIT (TX) ICON – Indicates
4
3. CHANNEL NUMBER – Changes from
5
4. KEY LOCK ICON – Indicates KEY
6
5. RECEIVE (RX) ICON – Indicates radio
6. TRANSMIT POWER LEVEL ICON –
7. PTT Button – Press and hold to trans-
11
8. ALL/LOCK Button – Press to send a
9. MIC – Built-in microphone.
10. SPEAKER – Built-in speaker.
11. ANTENNA
12
12. EXTERNAL SPEAKER/MIC/CHG.
13
13. POWER / MENU Button – Press and
14
15 14. SCAN Button – Press to enter SCAN
15.  U P▲andDOWN▼Buttons–Make
battery level is low.
radio is transmitting a signal.
1~22 on GMRS/FRS band.
LOCK mode is on.
is receiving a transmission.
Indicates TX Power setting (H/L).
mit voice communication.
CALL Alert signal. Press and hold to
turn KEY LOCK on/off.
JACK
hold for at least 3 seconds to turn the
radio on/off. Press momentarily to
access Menu mode.
mode.
adjustments in MENU mode.