Table of Contents
Advertisement
TV Logic DSP preset parameters
Parameter
Options
Roll
Off, Low, Med, High
Yaw
Off, Low, Med, High
Mono Rear
Steered Rear, Steered
Side, Steered All,
Mono All, Mono
Rear, Mono Side
Mono
In the Mono DSP preset you can choose to listen to:
Only one of two input channels, for use when different
languages or material are carried on each channel.
A combined version of the two input channels, for use if the
material was originally mono and has been conveyed on a
two-channel carrier.
40
If Party? is set to No, the combined or selected signal is played
only through the centre speaker, or the left and right speakers if
What it changes
there is no centre, to centrally localise high-frequency hiss and
clicks.
The degree of
left–right steering.
Note that if Party? is set to Yes, full range bass is played through
The degree of
any speakers that are not supplemented by a subwoofer, and
front–rear steering.
this may damage small speakers at high volume levels.
Which of the surround
Mono DSP preset parameters
channels are
generated by steering.
Parameter
Input
Academy
Party?
Options
What it changes
Auto L+R, Input L, The channel selected.
Input R, Input L+R
Off or On
Select On to include an
equalisation (recommended
by Lucasfilm Ltd) to correct
for a high-frequency
balance in some old mono
films. Ignored if Party? is
set to Yes.
No or Yes
Select Yes to play the mono
signal through all speakers,
including subs.
Advertisement
Table of Contents
