Stylus Pro XL+ Service Manual
4.1.4 Color Head Angle Adjustment
The color head angle adjustment is required when the color head is replaced or disassembled. If this
adjustment is not correct, a white banding problem may occur, or the black head timing may not match the
color head timing. The following figure illustrates the color head angle adjustment. The color head angle is
adjusted with the angular spacer. The angular spacer is attached only to the left side of the head base.
(Angle Adjustment Concept)
Figure 4-8. Color Head Angle and Angular Spacer Position
1.
Connect the PC to the target printer using a parallel interface cable and turn the printer on.
2.
Load BASIC on the PC, and run the program. You see the following destination select menu.
***** Customer *****
1. EAI, EAI (Latin America), EAL, ESP
2. EDG, EUL, EFS, EIS, EIB, EUL (Northern Europe), EUL (Middle East), EHK
3.
4. JAPAN
5.
6.
7. END
Select Menu ?
3.
Input the number for the destination. Then the main menu appears, as shown below.
If you enter an incorrect number as the destination selection, printer functions are not
guaranteed.
STYLUS Pro XL+ Program : Rev. X
customer :
1. Head VH input
2. Ink consumption counter reset
3. Head angular & linear adjustment
4. Head position check
5. BK. YMC head gap adjustment (head gap center )
6. Bi-D adjustment
7. Head VH indication
10. Change customer & data / END
0. Cleaning
Select Menu ?
Rev.A
Color He ad
Head Ba se
Carriage
(Bi-d center
Color Head
(Reverse Side)
An gu lar Spa cer
(Spacer Setting Location)
)
Adjustment
4-9