Removing The Paper Feed Roller Assembly - Epson Stylus Color 400 Service Manual

3.2.4.6.1 Removing the Paper Feed Roller Assembly

1. Remove the ASF assembly. (Refer to 3.2.4.6)
2. Remove the brake lever, releasing one leg of the torsion spring 41.2 from the hook of the ASF frame.
3. Remove the fixing axis bush from the right side of LD the roller axis and hopper lever release.
4. Move the left side of paper feed assembly part to the center and remove the cam fixed bush (white
plastic) attached to the left side of LD roller axis.
5. Push the LD roller axis to the left and remove the left axis fixed bush after releasing its hook.
6. Remove right and left sides of hopper assembly from the peaking of the ASF frame.
7. Uplifting the right side of paper feed roller assembly a little bit, push the LD roller axis to the right
and remove it from the left side of the ASF frame.
8. Holding the hopper assembly by hand, remove the cam part of hopper assembly from the right holes
of ASF frame.
The procedures by here should disassemble right and left roller assembly and hopper assembly.


During disassembly and assembly of the hopper assembly, do not let the grease on the cam
parts attach to the other parts. Wipe it if grease attached to the other parts.


Be careful for the direction of the hopper lever release, when installing it.


Make sure that right and left fixed bushes are installed steadily and do not slip off.


During assembly, attach the cam fixing bush after installing CD roller-axis to the ASF frame.


When installing right and left paper feed roller assemblies to the LD roller axis, a black paper
feed roller assembly comes to right side and the EPSON standard color one comes to left on
the axis.
Figure 3-16. Disassembly of ASF Assembly
Rev. A
Chapter3 Disassembly and Assembly
WORK POINT
3-19