Adjusting The Switch For The Trimming System - Duerkopp Adler 559 Service Instructions Manual

10.4 Adjusting the switch for the trimming system

1
Caution: Danger of injury !
Switch the main switch off.
Adjust the trimming system only with the machine switched off.
Standard checking
Before the fabric support plate continues transporting the fabric, the
cutting stamp must be in its upper position.
In order to avoid a possible collision, switch 1 checks the position of
the cutting stamp.
Correcting the height of the switch
–
Loosen screw 2.
–
Adjust the height of switch 1 accordingly.
–
Tighten screw 2.
2 1
3
33