Programmable Functions; Generating A New Program - Duerkopp Adler 550-16-23 Operating Instructions Manual

5.3 Programmable Functions

5.3.1 Generating a New Program

The machine settings described in the following are saved in memory
with each program.
The generation of a new program starts with the entry of a non-existent
program number.
–
Press the "P" key.
–
Enter a 2-digit program number
The left display blinks.
(If the left display does not blink the selected program already
exists.)
–
Hold down the "Y" key and tap the "P" key.
"01" appears in the middle display.
The dots in the middle display blink.
The dots in the "Step" and the "Sleeve Side" displays blink.
Note:
One can alternate between left and right piece with the "E" key until the
first fullness value/ special function has been selected (the sleeve side
display no longer blinks).
–
Enter a fullness value by pressing one of the keys from 0 to 15.
If desired, activate supplementary functions for the step by
pressing on one of the following keys :
- F : Supplementary thread tension on / off
- F + 1: Needle thread tension on/ off
–
Press the knee switch.
The next step is selected.
The entered value is saved.
The next value can be entered.
–
This programming order can be continued up to step 13.
–
Press the "E" key.
The established values are mirrored for the second piece and
saved to memory.
or
–
Press the "Y" +"P" keys.
The established values are saved only for the current piece and
are not mirrored.
Note:
During teaching, one can go back one step at a time with the "Y" key.
1
23