Tool Inspection - CEN-TECH 67980 Set Up And Operating Instructions Manual

Operation Instructions
breakage and any other condition which may affect its operation.

U se only accessories that are recommended by the manufacturer
2 0 4 B
for the tool.

D ry your hands before operating the tool or charging the battery.
2 0 5 B

A lways use appropriate personal protective equipment while
2 0 6 B
handling and using the tool. Appropriate personal protective
equipment always includes safety glasses and gloves, and may
include latex or rubber gloves, face shields, goggles, protective
clothing, respirators and steel toed footwear.

Protect against excessive heat. The tool should be kept away
from heat sources such as radiators, stoves or others products
that produce heat. Do not use the tool near moving machinery or
areas where the temperature will exceed

S tore the tool, charger and all cables in a locked area out of the
2 0 9 B
reach of children and people unfamiliar with the tool.

5 .3 Tool Inspection

2 3 B
W ARNING: Before using, inspect your tool and correct any
2 1 0 B
problems to reduce the risk of serious injury from electric shock and
other causes and to prevent damage to the tool.

M ake sure the power is OFF.
2 1 1 B

C lean any oil, grease or dirt from the tool, especially on the
2 1 2 B
buttons and ports. This helps to prevent the tool from slipping
from your hands.

I nspect the imager head lens for condensation. To avoid
2 1 3 B
damaging the tool, do not use the tool if condensation forms
inside the imager head. Let the water evaporate before using
again.

I nspect the full length of the cable for cracks or damage. A
2 1 4 B
damaged cable could allow water to enter the tool and increase
the risk of electric shock.

M ake sure the connections between the display unit and imager
2 1 5 B
head and cable are tight. All connections must be properly
assembled for the cable to be waterproof.

C heck if the warning label is present, firmly attached and
2 1 6 B
readable. Do not operate the tool without the warning label.
113° F (45° C).
17
Tool Inspection