Stop Motor Setting S359 600045 Xxx - Efka Dc 1600/Da82Ga; Setting Position Reader; Stop Motor Setting S359 600052 Xx - Efka Vd 552/6F82Fa; Changes Of Setting Parameters Of Stop Motor Setting Considering Original Producer Setting - Duerkopp Adler 525 Instruction Manual

12.1 Power supply 1 x 230 V - DC motor

12.5 Stop motor setting S359 600045 XXX - EFKA DC 1600/DA82GA

12.5.1 Setting position reader

- set the parameter 170, the display will show Sr1 (reference position)
- depress the pushbutton >>, the display will show PoS 0 and the changing rotation symbol
- turn the hand wheel until the rotation symbol disappears
- turn the hand wheel in such a way, so that the needle point ,when moving downward, is on the level of the throat plate
- depress the pushbutton E and pass to the parameter 171
- set the parameter 171, the disply will show Sr2 (all positions)
- depress the pushbutton >>
- the display will show 1 XXX (value of the bottom position)
- turn the hand wheel, until the value XXX begins to change
- turn the hand wheel at the value of the bottom position angle (160 on the panel)
- depress the pushbutton E
- the display will show 2 XXX (value of the top position)
- turn the hand wheel, until the value XXX begins to change
- turn the hand wheel at the value of the top position angle (460 on the panel)
- depress the pushbutton P 2x (return to the sewing mode)
- tread shortly forward the pedal (memory entry)

12.5.2 Changes of setting parameters of stop motor setting considering original producer setting

Parameter Parameter
No value
111 -
170 -
171 1 160
2 460
190 300
202 120
210 200
213 5

12.6 Stop motor setting S359 600052 XX - EFKA VD 552/6F82FA

12.6.1 Setting position reader
1 A
1
Positions are set by means of discs with cut outs directly in positon reader.
Setting of the lower position:
- dismount the guard of the position reader
- switch on the mains switch
- tread shortly pedal forward (the machine stops in the needle lower position)
- switch off the mains switch
- turn the beginning of the recess 1 of the overlapping disks in such a way, so that the machine stops with the needle in the
position of 3 mm behind the bootom dead center
- check up in repeating the procedure
Setting of the top position of the thread lever:
- tread the pedal rearward (the machine stops in the needle upper position)
- switch off the mains switch
- turn the beginning of the recess 2 in such a way, so that the machine stops with the thread lever in the top dead centre
- check up in repeating the procedure.
Max. revolutions (according to a type of machine)
Reference position
Lower position
Upper position
Switch on angle of thread trimmer (210
Delay of start run after switch off the signal foot
Stopping time for fancy bar
Time off full power of backtacking
°
)
2 A
2
13