Replacing The Front Audio And Usb Assembly - Lenovo ThinkStation D30 User Manual

7. To install a new hard disk drive enablement module, align the hole in the hard disk drive enablement
module with the plastic standoff on the system board, and then position the hard disk drive module over
the corresponding connector on the system board.
Figure 38. Installing a new hard disk drive enablement module
8. Reinstall the hard disk drive fan assembly and close the PCI card retainer. See "Replacing the hard
disk drive fan assembly" on page 45.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 56.

Replacing the front audio and USB assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the front audio and USB assembly.
To replace the front audio and USB assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 30.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 31.
.
Chapter 5 Installing or replacing hardware
53