Installation; Water Connection - Baumatic BDW10 User And Installation Instructions Manual

Table of Contents

INSTALLATION

5.1 LEVELLING

Place the appliance in the spot where you want to install it. Use feet P (unscrew or screw in) to regulate

(if necessary) the height of each foot to assure that the appliance is in a fully level position.

If the appliance is positioned in a level position, its correct functioning is assured.

Maximum error = 2 degrees

After levelling the appliance, regulate the hook of the door closing mechanism, to assure that the door

closes perfectly.

In order to obtain a perfect seal adjust the door locking device but only after having levelled the machine

in its final installation position.

The water supply tube C, which accompanies the

dishwasher, attaches to a 3/4" water tap.

During the installation, the following instructions must be

followed:

• Attach tube C to the cold water supply A.

• If the tube is being attached to new pipes that have not

been used for a long time, you should let the water run

for some time before attaching the hose in order to make

sure that dirt and rust residues are eliminated.

• Make sure that the water pressure corresponds to the

range indicated on the data tag.

The appliance may be connected to the cold water sys-

tem. It must not be connected to the hot water system.

5.2 a LEAK PROTECTION/AQUA STOP (FOR BDW10)

As part of the security system your dishwasher has been installed with a leak detector (housed in

the base of the appliance). In the unlikely event of water leaking into the base of the diswasher, the

detector would activate and in turn initiating the aqua stop (which is part of the fill water hose) and

would shut off the incoming water supply.

1 2 3 4 5 6 7 8 9 0

2.1

Table of Contents

Show Quick Links

Table of Contents