Timing Of The Advancing Movement Of The Transport Foot - Duerkopp Adler 195 Service Manual

2.5.2

Timing of the Advancing Movement of the Transport Foot

16
1
The pressure foot should not move when the greatest possible stitch
length has been set and the stitch actuator lever is operated with the
machine arrested in position B.
Caution Risk of Injury!
Turn off main switch before adjusting.
Setting with the Gauge
–
Arrest the machine in position A.
–
Loosen the screws on the thrust eccentric 1.
–
Place the timing pin 3 in the tracing hole of the thrust eccentric 1
and bring into vertical position.
–
Retighten the screws.
Setting without the Gauge
–
Arrest the machine in position B.
–
Loosen the screws on the thrust eccentric 1.
–
Turn the thrust eccentric on the arm shaft so that the transport foot
does not move when the stitch actuator is operated.