460 MAINTAINING YOUR VEHICLE
Clutch Hydraulic System
The clutch hydraulic system is a sealed maintenance-free
system. In the event of leakage or other malfunction, the
system must be replaced.
Clutch Linkage
If the clutch pedal linkage begins to squeak or grunt, the
clutch pedal pivot bushings should be lubricated. Refer
to Fluids, Lubricants and Genuine Parts for the correct
lubricant type.
Rear Axle And 4x4 Front Driving Axle Fluid Level
Refer to Fluids, Lubricants and Genuine Parts for the
correct Fluid type. For normal service, periodic fluid level
checks are not required. When the vehicle is serviced for
other reasons the exterior surfaces of the axle assembly
should be inspected. If gear oil leakage is suspected
inspect the fluid level.
This inspection should be made with the vehicle in a level
position. The fluid level should be even with the bottom
of the fill hole for the Manufacturer's C205F HD Front
Axles. The fluid level should be 5/8" (16 mm) below on
9 1/4" Manufacturer's Rear Axles.
For all 2500/3500 Model axles, the fluid level should be
1/4" ± 1/4" (6.4 mm ± 6.4 mm) below the fill hole on the
9.25" Front and 3/4"± 1/4" (19 mm ± 6.4 mm) on 10.5"
Rear axles. The 11.5" Rear Axle level should be 1/4" ±
1/4" (6.4 mm ± 6.4 mm) below the fill hole.
Drain and Refill
Follow the Maintenance Schedule for recommended
front and rear axle fluid change intervals.
Lubricant Selection
Refer to Fluids, Lubricants and Genuine Parts for correct
fluid type.