Adjusting The Fan Speed; Fan Only - Sanyo KS2432 Instruction Manual

NOTE
2. Adjusting the
Fan Speed
A. Automatic
Cooling mode:
NOTE
B. Manual

3. Fan Only

14
Operation with the Remote Control Unit (continued)
Choose the best position in the room for the remote control unit, which
•
also acts as the sensor for room comfort and transmits the operating
instructions. Once you've found this best position, always keep the
remote control unit there.
This appliance has a built-in 3-minute time delay circuit to ensure
•
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the unit
will restart automatically after three minutes.
Simply set the FAN SPEED selector to the
A microcomputer in the air conditioner automatically controls the fan speed
when the mode is selected. When the air conditioner starts operating,
the difference between the room temperature and the set temperature is
detected by the microcomputer which then automatically switches the fan
speed to the most suitable level.
When difference between room
temperature and set temperature is
4 °F and over
Between 4 °F and 2 °F
Below 2 °F
The above table assumes that the sensor on the remote control is being
used. If the sensor on the indoor unit is being used (the
actual operation may differ slightly from the operation described in the
table.
(Refer to ''A/C SENSOR button'' on page 10.)
If you want to adjust fan speed manually during operation, just set the FAN
SPEED selector as desired. [
STEP 1
FAN SPEED
STEP 3
If you want to circulate air without any temperature control, follow these
steps:
STEP 1: Press the MODE selector button to switch to the fan mode.
( )
STEP 2: Press the ON/OFF button.
STEP 3: Press the FAN SPEED button to select the fan speed of your choice
( , , or
position.
FAN SPEED
High
Medium
Low
, , or ]
ON I /OFF
NIGHT
OFF ON
SETBACK
MODE
CLOCK
FLAP HH TIMER
SELECT
MM
A/C
ACL
TIME SET
SELECT
SENSOR
BATTERIES
).
indicator is on),
STEP 2
OI-201-14EG