Sanyo KS2432 Instruction Manual page 10

PROGRAM button
TIMER SELECT button
MODE selector button
(COOL)
(FAN)
FLAP button
FAN SPEED selector
button
1 HR. TIMER button
(1-HOUR OFF TIMER)
ACL button
(ALL CLEAR)
A/C SENSOR button
NOTE
NOTE
10
Remote Control Unit (continued)
For details, see ''Setting the Timer''.
Press this button to select the mode you want to program.
No display : The timer does not operate.
: The air conditioner stops at the set time.
OFF
: The air conditioner starts at the set time.
ON
: The air conditioner stops and starts, or starts and stops, at
the set times every day.
Use this button to select COOL or FAN mode
: The air conditioner makes the room cooler.
: The air conditioner works only as a circulation fan.
Press this button to select the sweep function, which moves the flap up
and down automatically.
: The flap moves up and down automatically.
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
: When you press this button, regardless of whether the unit is
1 HR.
operating or stopping, the unit operates for one hour and then
shuts down.
Puts the remote control unit into pre-operation status. Always press this
button after replacing the batteries.
When you press this button (use a small-tipped object such as a
ballpoint pen), the
temperature is detected by the sensor which is built into the indoor unit
and the air conditioner is controlled accordingly.
If the remote control is located near a heat source, such as a space
heater or in direct sunlight, press the A/C SENSOR button to switch to
the sensor on the indoor unit.
The remote control unit sends the temperature signal to the air
•
conditioner regularly at three minute intervals. If the signal from the
remote control unit stops for more than ten minutes due to the loss of
the remote control unit or other trouble, the air conditioner will switch
to the temperature sensor which is built into the indoor unit and control
the room temperature. In these cases, the temperature around the
remote control unit may differ from the temperature detected at the air
conditioner's position.
Operation when the outdoor temperature is low
•
If an indoor unit connected to a ''CL-'' type outdoor unit is operating in
the cooling mode during the winter months when the outdoor
temperature is low, setting the FAN SPEED selector to
can result in intermittent operation to prevent freezing. In such cases,
use the (high fan speed) or
mark will appear at the display. And the room
(medium fan speed) setting instead.
(low fan speed)
OI-201-10EG