AEG Electrolux LAVAMAT 76825 User Information page 20

Problem
The washing machine
vibrates when operating
or is not stable.
Washing has not been
spun.
Water is running out
from under the washing
machine.
Wash water is foaming
excessively. At the end
of the washing cycle,
the spin stops. The
OVERDOSING indicator
lights up.
E20 appears.
The END indicator
flashes 2x, and an
acoustic signal sounds
2x.
(Problems with water
inflow.)
Fabric softener was not
rinsed in, the compart-
ment w for condition-
ers is full of water.
20
Possible cause
The transport lock has not
been removed.
The screw feet not correctly
adjusted.
Only a few large items of
washing in the drum.
Screw connection on the in-
let hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
Too much detergent has
probably been used.
Kink in drain hose.
Do not exceed the maxi-
mum pump height of 1m.
Drain pump is blocked.
For sink spigot connections:
The sink spigot is blocked.
Fabric softener insert in the
compartment for condition-
ers is not correctly attached
or is blocked.
Remedy
Removing the transport lock.
Adjust the feet as described
in the installation and con-
nection instructions.
Always load the drum as full
as possible. Mix large and
small items.
Screw the inlet hose on
tightly.
Replace drain hose.
Close the cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
Straighten the hose.
Please contact customer
service.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
Clean the sink spigot.
Clean the detergent drawer,
insert the fabric softener
insert firmly.