AEG LAVAMAT 86810 User Information page 29

Problem
Display shows: "No inco-
ming water/Check tap &
Hose"
Washing machine vibrates
when operating or is noisy.
Washing has not been
spun.
Water is running out from
under the washing
machine.
Display shows: "Excess De-
tergent"
Display shows:
– "No drain - check/drain
hose/filter" or
– "Pump Blocked"
Fabric softener not rinsed
in, compartment for ad-
ditives is filled with water.
Possible cause
Tap turned off.
The filter in the threaded
inlet hose fitting is
blocked.
Water tap is blocked
with limescale or faulty.
Transit packaging has
not been removed.
Screw feet not correctly
adjusted.
Only a few large items of
washing in the drum.
Screw connection on the
inlet hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in
the door.
Emergency drain hose is
leaking.
Probably too much de-
tergent has been used.
Kink in drain hose.
Maximum pumping
height of 1m exceeded.
Drain pump is blocked.
For sink spigot connec-
tions: spigot is blocked.
Conditioner insert in the
compartment for addi-
tives is not correctly at-
tached or is blocked.
Remedy
Turn the tap on.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Check the water tap and have
it repaired if necessary.
Remove transit packaging.
Adjust feet according to the
Installation and Connection
instructions.
Always load the drum as full
as possible. Mix large and
small items.
Screw the inlet hose in firmly.
Replace drain hose.
Close the cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Dose detergent exactly as in-
structed by manufacturer.
Remove kink.
Please contact your Service
Force Centre
Switch off the appliance. Pull
out mains plug.
Clean the drain pump. Re-
move foreign bodies from the
pump housing.
Clean out spigot.
Clean the detergent dispenser
drawer, insert the conditioner
insert firmly.
29