AEG LAVAMAT 51635 User Information page 30

Operating Instructions
Problem
The washing machine
vibrates during opera-
tion or is unstable.
Water runs out from
under the washing
machine.
The washing machine
does not spin; there is
water in the drum.
30
Possible Cause
The transport packaging has
not been removed.
The machine is not level.
There is very little washing in
the drum (e.g. only one
dressing gown).
The water could not be com-
pletely pumped out before
spinning because
the drain hose is kinked or
the drain pump is blocked.
The screw connection on the
inlet hose is leaking.
The drainage hose is leaking.
The drain pump cover is not
correctly closed.
Washing is caught in the
door.
The emergency emptying
hose is not correctly sealed
or is leaking.
RINSE HOLD has been
selected.
Soaking program has fin-
ished.
Remedy
Remove transport packaging
according to the installation
and connection instructions.
Adjust the feet according to
the installation and connec-
tion instructions.
This does not impair the
function.
Check the drain hose and
remove any kink if necessary,
or clean the drain pump and,
if required, remove foreign
bodies from the pump hous-
ing.
Tighten the inlet hose screw
connection
Check the drainage hose and
replace it if necessary.
Close cover correctly.
Stop the program and
remove the washing caught
in the door. Restart the pro-
gram.
Seal the emergency empty-
ing hose correctly (see sec-
tion "Carrying Out an
Emergency Emptying"). Call
your local AEG Service Force
Centre if the emergency
emptying hose leaks.
Cancel RINSE HOLD.
Release SOAKING button
(main wash program will fol-
low).