Bush IDLCD2204HD Instruction Manual

Bush IDLCD2204HD Instruction Manual

22" lcd tv

Advertisement

22
IDLCD2204HD
The Gold T echnical Support Line:
1902 215 259
Personal Product Support
(Charges will apply at $2.95 per minute)

Advertisement

Table of Contents
loading

Summary of Contents for Bush IDLCD2204HD

  • Page 1 IDLCD2204HD The Gold T echnical Support Line: 1902 215 259 Personal Product Support (Charges will apply at $2.95 per minute)
  • Page 2: Introduction

    INTRODUCTION Thank you for buying this Bush product, which is designed to give you many years of trouble-free service. You may already be familiar with using a similar unit, but please take time to read these instructions. They are designed to familiarise you with the unit s m any f eatures and to ensure you get the very best from your purchase.
  • Page 3: Table Of Contents

    CONTENTS INTRODUCTION................1 SAFETY INSTRUCTIONS............3 INSTALLATION................. 4 WALL MOUNTING INSTALLATION GUIDLINES......4 ACCESSORIES................5 FRONT PANEL................5 KEY BOARD................6 REAR PANEL................6 ANTENNA CONNECTION............7 CONNECTING TO PC..............8 PC PRESET................9 CONNECTING TO AV EQUIPMENTS...........10 REMOTE CONTROL..............11 BATTERY INSTALLATION............11 KEYS FUNCTION..............12 OPERATION................13 BASIC OPERATION..............13 TELETEXT................14 EPG..................15 MENU OPERATION..............16 TROUBLESHOOTINGS............21...
  • Page 4: Safety Instructions

    SAFETY INSTRUCTIONS 1. Do not use this apparatus near water. 2. Clean only with dry cloth. 3. Do not block any ventilation openings. Install in accordance with the manufacturers instructions. 4. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
  • Page 5: Installation

    INTSTALLATION INSTALLATION NOTES This TV can be connected to AC 100-240 Volts. 50/60 Hz. Never connect to a DC supply or any other power supply. Locate the TV in the room where light does not strike the screen . Total darkness or a reflection on the picture screen can cause eyestrain.
  • Page 6: Accessories

    INTSTALLATION ACCESSORIES AC Power Cord......1 Infrared Remote Control....1 User s M anual ......1 Battery(AAA)......2 FRONT PANEL Remote control sensor. Indicator LED: GREEN POWER ON. STANDBY. POWER MUTE NICAM RECALL Key board(see next page). TV MENU INPUT ENTER Power: Press this button to the status DVB MENU SOUND EXIT...
  • Page 7: Key Board

    INSTALLATION KEY BOARD SOURCE SOURCE MENU MENU VOL+ VOL+ VOL- VOL- 1 SOURCE To display the input source menu. 2 MENU To display main MENU. 3 CH+/CH- In TV mode to change the channel up and down. In MENU mode, to select the menu items . In standby mode, it can turn on the TV.
  • Page 8: Antenna Connection

    INSTALLATION ANTENNA CONNECTION Note: Aerial connections:IEC(female). Input impendance:75 unbalanced.
  • Page 9: Connecting To Pc

    INSTALLATION CONNECTING TO PC STEPS: Be sure both the TV and computer are set to Power off. 1.Connect VGA and audio cable. 2.Connect the power cord. 3.Power on the TV, switch the input source to VGA mode. 4.Power on the PC. This sequence is very important.
  • Page 10: Pc Preset

    INSTALLATION PC PRESET PRESET MODE(recommended resolution is 1024*768@60Hz) V.Freq.(Hz) H.Freq.(KHz) RESOLUTION 720*400 31.47 640*480 31.47 800*600 35.156 800*600 37.88 800*600 46.88 800*600 48.08 1024*768 48.36 1024*768 56.48 1024*768 60.02...
  • Page 11: Connecting To Av Equipments

    INSTALLATION CONNECTING TO AV EQUIPMENTS This TV provides one group of AV, one S-Video,one group of YPbPr for convenient connection to VCR, DVD or other video equipment. Please refer to the owner s manual of the equipment to be connected as well. You can use the input terminals on TV set rear as follows.
  • Page 12: Remote Control

    REMOTE CONTROL BATTERY INSTALLATION 1. Remove the battery cover. 2. Inserting the 2 AAA 1.5V batteries making sure the polarity (+ or -) of the batteries matches the polarity marks inside the unit. 3. Mount the battery cover. Replace with new batteries when the TV set begins to show the following symptoms: Operation is unsteady or erratic.
  • Page 13: Keys Function

    REMOTE CONTROL KEYS FUNCTION 1:POWER:To set the TV to standby or power on. 2:NUMERIC KEY: For direct access to channels. POWER MUTE 3:TV MENU:To display TV menu. 4:CURSOR:To move within the menu. AUDIO 5:CH.LIST:To display the channels list. 6:VOL+/- :To adjust sound level. RECALL 7:PIC:To switch picture mode.
  • Page 14: Operation

    OPERATION BASIC OPERATION TURN ON THE UINT Press the POWER button on the remote control to switch on the power. The power indicator will light up in green colour, press the POWER button again to switch off the power, and the indicator will change to red. CHANNEL SEARCH Press the SOURCE button on the remote control to select the TV or DTV input mode, and press the OK button to confirm.If you are using the unit for the first time, an...
  • Page 15: Teletext

    OPERATION TELETEXT Teletext is an information system broadcast by certain channels which can be consulted like a newspaper. It also offers access to subtitles for viewers with hearing problems or who are not familiar with the transmission language (cable networks, satellite channels, etc.) Press: You will obtain: This is used to enter or exit teletext mode.
  • Page 16: Epg

    OPERATION EPG (Electronic Programme Guide) The EPG (Electronic Programme Guide) menu is used to look at what is being broadcast on a DTV or Radio channel at a later point in time. Press the EPG button to access the EPG menu, t he detailed programme information of the channel currently being viewed will be displayed.
  • Page 17: Menu Operation

    OPERATION MENU OPERATION 1.CHANNEL MENU The first item of the menu is CHANNEL menu( for TV source only). CHANNEL Auto Tuning DTV Manual Tuning ATV Manual Tuning Programme Edit MENU EXIT You can search channels and edit programs here. 1).Auto Tuning:Search all the channels automatically(ATV, DTV & Radio) Please select country first then select Start to update info Country selection...
  • Page 18 OPERATION 3). ATV Manual Tuning :You can change the sound system to search the analog TV channels and fine tune the channels, then store the channels you selected. ATV Manual Tuning Storage To System Current CH Search Fine-Tune Skip Frequency 255.25MHz EXIT SAVE...
  • Page 19: Picture Menu

    OPERATION 2. PICTURE MENU The second item of the menu is PICTURE menu. You can adjust picture effect here, including contrast, brightness and colour as well as other picture functions. Press the buttons to select items and press the buttons to adjust. PICTURE PICTURE Colour Temp...
  • Page 20 OPERATION 4.TIME MENU The forth item of the menu is the TIME menu. You can adjust the clock, power on/off time, sleep timer and time zone as well as other time clock functions. Press the buttons to select and press the buttons to adjust.
  • Page 21 OPERATION 6.LOCK MENU The sixth item of the menu is the LOCK menu. You can lock system, change password, block programme, set parental guidance, restore factory default and set maximum volume control. LOCK Lock System Change Password Block Programme Parental Guidance Restore Factory Default Max Volume EXIT...
  • Page 22: Troubleshootings

    TROUBLESHOOTINGS Problem Check Picture Audio antenna position, direction Snow Noise or connection antenna position, direction Ghost Normal audio or connection electronic equipment,car/ Interference Noise motorcycle,fluorescent light Volume(check if mute is activated or if the audio system Normal Picture Mute connections are not correct) Power cord is not inserted Power switch is not opened Contrast and brightness/volume...
  • Page 23: Technical Specification

    TECHNICAL SPECIFICATIONS LCD : ViewIng Picture Size(diagonal) Resolution 1366x768 Aspect Ratio 16:9 16.7M Display colours 400 CD/M Brightness Contrast ratio 800:1 Response time 5 ms 170(H)/160(V) View angle Digital TV: DVB-T TV system Analog TV: PAL/SECAM Audio: MPEG2 Audio Layer I&II DVB-T decode Video: MPEG2 Transport MP@HL Demodulator : COFDM...
  • Page 24: Warranty

    In the unlikely event that your product fails to work normally , please contact the Bush Warranty on 1800 509 394 (Australia) or 0800 450 259 (New Zealand) and have your receipt of purchase on hand.
  • Page 25 PO BOX 6287 Silverwater NSW 1811 www.bushaustralia.com.au Ver 10-JAN-2009...

Table of Contents