Sansui HDPDP4200A Owner's Manual page 14

Connections to other equipment
To connect the Plasma Display to a DTV receiver/set-top box
If you connect a DTV receiver/set-top box, connect your Plasma Display to a DTV receiver/set-top box using a
component video cord.
Rear lower of the Plasma Display
To connect an audio system
This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using
the Plasma Display's remote control.
To control the audio, turn on the Plasma Display and the stereo amplifier, and turn off the Plasma Display's
built-in speakers (see "Turning off the built-in speakers" on page 32).
VARIABLE AUDIO (L)
OUTPUT
VARIABLE AUDI (R)
OUTPUT
NOTE:
To hear sound when using an external audio amplifier, the volume of both the Plasma Display and the
amplifier must be set above 0 (zero).
For example, if the volume of the Plasma Display is set to 0, you will not be able to hear any sound, even if
the volume of the amplifier is at its highest level.
14
To COMPONENT IN 1 (or 2)
Audio cord (not supplied)
Video cord (not supplied)
Audio cord (not supplied)
To Audio OUT
;
2
*
2
4
To Component OUT
Amplifier
To Audio (L) Input To Audio (R) Input