Saab 9-3 Owner's Manual page 91

93_US_MY09.book Page 91 Tuesday, April 15, 2008 10:30 AM
When the engine is started, the function that
was selected when the engine was
switched off is displayed, with the following
exceptions:
• Temp is displayed if the outside tempera-
ture is between 26 and 38°F (–3 and
+3°C).
• D.T.E. is displayed if less than or equal to
30 miles (50 km).
Outdoor temperature
WARNING
Remember that roads can be icy even at
temperatures of above 38°F (+3°C),
especially on bridges and stretches of
road that are sheltered from the sun.
The Temp function is always activated
(even in NIGHTPANEL mode) if the outdoor
temperature rises or falls to between 26 and
38 °F (–3 and +3 °C).
If the temperature sensor, located under the
front bumper, is covered by snow or ice,
temperature readings will be unreliable.
Setting values
1 Select one of the functions using the
steering wheel controls, or
• Dist (preset to 100 miles (100 km) if not
previously set)
• Speed Ø
• Speed W (preset to 55 mph (90 km/h).
2 Press and hold the SET button until
given audible confirmation.
3 Use the steering wheel controls to select
the value. (Press CLR to reset the
value.)
4 Press the SET button to finish setup.
Using DIST as a trip meter
1 Select Dist using the steering wheel
controls, or .
2 Press and hold the CLR button for
approx. 1 second.
An arrow will now appear on the right-hand
side of the display, indicating that the trip
meter is running.
Instruments and controls
Resetting a single function
1 Select the function you wish to reset
. using the steering wheel controls,
.
• Fuel Ø
• Speed Ø
• Trip (Dist used as trip meter).
2 Press and hold the CLR button for
approx. 1 second.
The selected function will now be reset.
91
or